przez piter26 » 4 gru 2019, o 20:08
Właśnie przez kabel Deep flash wprowadzasz w tryb edl. To jest tryb "awaryjny".
Możesz to również zrobić w ten sposób
After installing all the drivers and the flash tool the most important step is to boot the phone into edl mode or 9008 port which is very tricky step
STEPS:-
1. Power off the phone completely.
2. Press the volume up button for almost 15 sec without leaving press the power button for .5 sec (don't leave the volume button).
3. Again press the power button and hold it and immediately put the cable into the pc .
(note:- these time two buttons are pressed power button and the volume up button which was pressed in step two)
4. Leave both buttons when you receive the connection sound on the pc and check in the device manager now you connected to
the 9008 port instead of the 900E port.
(note:- step 4 can be symbolizes as you will get zuk logo flashed for a split of second after connecting the cable to the pc and
after that whole screen will be black and then after leave all the buttons and flash the phone with qpst)
Wysłane z mojego Mi Note 3 przy użyciu Tapatalka